Effective care for concrete vibrators

Odpowiada ekspert wydawnictwa Harmonia

Effective care for concrete vibrators

Postautor: concretemixer » 2 wrz 2016, o 03:49

Effective care for concrete vibrators
Concrete vibrator has a large amplitude, high frequency, light weight, reasonable structure, safe operation, maintenance and ease of use. The vibrator has a compressed air source is widely used in construction works in construction, for a variety of dry and hard and the injection of concrete vibration tamping work, which is characterized as follows:
1. This vibrator with compressed air as gas source, vane pneumatic motor driven, flexible shaftconstruction sand screw conveyor drive, reasonable structure, easy connection. Without power, humidity and other conditions, gas and coal dust in the mine and other mines, "set side" cement tamping works contain is particularly applicable, absolutely safe and reliable.
2. With a large amplitude, high frequency, can be adjusted. (According to site requirements, the available inlet pressure to adjust the frequency)
3. The power large, flexible shaft drive, install the operating, maintenance and easy to use, especially for special mining conditions apply.
Concrete vibrator use and maintenance:
The vibrator motor, compact structure, internal parts with precision, requiring the operator carefully maintained.
1. Before using ventilation units should rotate 30 °, so that the holes align, let exhaust smooth, 3-5 minutes in commissioning, check whether the normal operation, startup is flexible. Without exception, can be put to use (such as vibration head does not move, you can head wind vibration motor portion straight, when tapped on the ground).
2. The inlet hose must not be less than 25 mm inner diameter, air pressure of not less than 4-5 kg ​​/ cm.
3. When connected to the air supply pipe to pipe joints and blowing booty, to prevent debris entering the cylinder caused by wear and tear or rotor jammed parts.
4. vibrator use according to site requirements, the control inlet pressure to adjust the vibration frequency.
5. The pneumatic vibrator to stop using, to exhaust sleeve rotation 30 °, so that the exhaust hole is closed, to avoid impurities into the cylinder from the exhaust vents.
6. When the wind motor maintenance, the upper and lower end caps bearing cavity to add a little grease (2 calcium-based grease SYB1401-62), to ensure the bearing lubrication.
7. Long-term storage should be removed for cleaning, oiling sealed, in order to avoid corrosion.
8. The wind vane motor badly worn, the rotor will be stuck, unable to work. You can now unscrew the handles, with M10 Luo nail ejection cover, thus removing burrs or replace the wiper blades new blades.
9. with or detailed repair instructions movable submersible pumps BQF-IV according to Our wind.
jac 16 cubic meters ajax concrete mixer price
power-gen robin concrete vibrator
concretemixer
 
Posty: 167
Rejestracja: 23 cze 2016, o 10:46

Wróć do Ksiegarnia logopedyczna



Kto jest online

Użytkownicy przeglądający to forum: Nie ma żadnego zarejestrowanego użytkownika i 1 gość

cron